AEG Automotive 97216 SP 25 Safety Jump Leads, Jumper Cable, Starter Cable, with Voltage Spike Protection in Storage Bag, 2 x 3.5 m, DIN 72553

What do you need a jump cable for? Perhaps you have left an interior lighting, the radio or the parking light on? Or your battery has just reached the end of its life? Car batteries usually do not show signs of problems until it is too late. Then your car just won't jump anymore. No matter how old (or new) your car is, having a jump leads such as the AEG Automotive SP 25 jump leads is a must. The AEG jump leads with StartProtect technology. The AEG jump leads SP 25 "StartProtect" have a red and a black cable with fully insulated Best-Contact terminals. The cables with copper-aluminium technology correspond to the conductance of a 25 mm² copper jumper cable, thus meeting DIN 72553. The StartProtect voltage peak protection prevents damage to the sensitive on-board electronics such as ABS, airbag or HiFi of both vehicles involved. During start-up operations without this protective device, voltage spikes of up to 800 V can occur in the nanosecond range, which can lead to pre-damage or even total failure of individual electronic components. A starter cable equipped with StartProtect prevents these voltage spikes from being penetrated. The colours are important indications of where the cables are to be installed. In any electrical system, electrical energy flows from the negative pole of a battery through a system of wires to the positive pole to drive something - in this case the vehicle's starter - along the way. In order for a jump starter to work properly, it is necessary to ensure that the correct terminals are connected. The red cable of the AEG jump leads always represents the side that should be connected to the positive pole. The black starter cable should be connected to the negative pole. Touch only the intended target with the clamps of the jump cable. The AEG Automotive jumper cable is suitable for combustion engines up to 2500 cm³ and a voltage of 12 V. In a practical storage bag, it is protected from damage and always at hand. AEG: Innovations are tradition +F87

• With StartProtect – the voltage peak protection prevents damage to the sensitive on-board electronics of both vehicles involved (ABS, airbag, HiFi etc.)
• A starter cable equipped with StartProtect prevents high inductive voltages from penetrating the sensitive on-board electronics of the vehicles involved in the starting process.
• During start-up operations without this protective device, voltage spikes of up to 800 V can occur in the nanosecond range, which can lead to pre-damage or even total failure of individual electronic components.
• Quick help for the low battery and with fully insulated best contact terminals copper aluminium technology. Conforms to the conductance of a traditional 25mm² copper jumper cable. Complies with DIN 72553.
• Conductor cross section: equivalent to 25mm² copper cable. Cable length: 2 x 3.5 m. Recommended for the following engines: petrol engine up to 5500 cm³ / diesel engines up to 3000 cm³. Voltage: 12V. Comes with a handy storage bag.